PACKAGING
QUIK-ROK® is supplied in 52.5 lb. pails.
PHYSICAL PROPERTIES
Color:…………………………………………………………………………Gray
Set Time:………………………………………………………………… 7-9 minutes
Expansion:…………………………………………………………… 0.2% maximum
COMPRESSIVE STRENGTH
One hour wet:………………………………………………………… 6,000 psi
One day dry:…………………………………………………………… 9,000 psi
Ultimate:……………………………………………………………… 14,000 psi

INSTRUCTIONS FOR USE:
AS A NEAT MIX FOR ANCHORING:
Core-drill a hole using the applicable dimensions from Table 1 below

Ameristar Quik-Rok 1002

CAUTION:
Since the hole will serve as the form for the QUIK-ROK® pour, it is imperative that all loose dirt, rocks
and other foreign matter be removed. Because QUIK-ROK® is an expansive product, the area surrounding
the hole must be structurally sound, either by having a sufficient mass of well-cured concrete or an equally
supportive amount of steel reinforcing. NEVER use QUIK-ROK® in holes cut into narrow or thin-capped
walls, curbs or masonry items such as filled block or brick. Always ensure that no edge of adjoining concrete
is less than 2 hole diameters from the outside perimeter of the hole.

Water used in mixing QUIK-ROK® must be as pure as possible; if it is drinkable, it is probably suitable.
Soluble salts such as sodium chloride, sodium sulfate and magnesium sulfate must not be present in
large amounts as they could react adversely with the QUIK-ROK® material. Mix up to 1 part of pure water to
3-1/2 parts of powder by volume, using as little water as necessary for pourability. Accurate measuring of the
ingredients in a properly mixed first batch will ensure consistency on subsequent batches, provided the same
water-to-QUIK-ROK® ratio is maintained. Variations in the ratio will affect absorption and strength over time.
QUIK-ROK® will set in 7-9 minutes when both the QUIK-ROK® and water are at 70°. To maintain set time
consistency use warm water in cold weather and cold water in warm weather. Pouring in temperatures below
freezing is not recommended.

AS AN ADDITIVE:
To accelerate the set of a standard 1:2:3 concrete mix, substitute approximately 1.5 to 3 lbs. of QUIK-ROK®
for every 10 lbs. of cement in the mix. Stir thoroughly adding as little water as is necessary for flow.
When using the admixture to set columns or posts, the DIAMETER OF THE HOLE SHOULD BE AT
LEAST 3 TIMES DIAMETER OF POST, in most cases.

Download Fax Order Form

Discount Fence Supply, Inc.
8500 Hadden Rd. ° Twinsburg OH 44087
Phone (800) 878-7829 ° Fax (330) 650-9004
Customer Service